
This ZIP archive contains ZyNOS 2.20(B.17) | 10/21/1999 for Prestige P128+.

Also included is the default settings "P128E.ROM". You will not need it
unless you must reset all the Prestige's parameters, including the password.
Please see "How To Upgrade Prestige" section in release notes for how to
upgrade your Prestige.


There are two ZIP files:
----------------------------------------------------
p128e.zip for "European (DSS1)" ISDN switch type
----------------------------------------------------



The contents of these ZIP files are:
------------------------------------
a) README.TXT - This file
b) p128e.bin            - binary RAS firmware ZyNOS v2.20(B.17) | 10/21/1999
                          for the European "DSS1" ISDN switches
c) p128e.rom            - Default Settings for P128plus, European version
d) p128p_ZyNOS_v2.20(B.17).doc  - Release Notes and Manual Supplement, WinWord DOC
e) p128p_ZyNOS_v2.20(B.17).pdf  -                -"-     , Adobe Acrobat Portable File
f) p128p_ZyNOS_v2.20(B.17).rtf  -                -"-     , Rich Text Format

g) EPAPC093.EXE        - ZyXEL's "Embedded Protocol Analyzer" (EPA) interpreter
                         version 0.93 - for DOS
                         use Prestige's CI command sequences:
                        1.) isdn fw ana on
                        2.) .... dial to remote node
                                 for example: dev dial 1
                        3.) ...  if connected, disconnect from remote node
                                 for example: dev chan drop all
                        4.) isdn fw ana off
                        5.) isdn fw ana dump
                            -> save the dumped HEX data to ASCII file
                               note: there must not be any Prestige's command
                               line in that ASCII text - pure HEX only !!
                        6.) start EPAPC tool and 'load file', input the name
                            of previous stored ASCII text file.
                        7.) the EPAPC tool will now interpret all the dumped
                            HEX data and will display the ISDN D-channel
                            Protocol. You may save this interpreted data
                            into another ASCII text file for further study.

h) ZPKTTOOL.EXE        - ZyXEL's "PKT-TOOL", PPP and IP packet interpreter
                         version 0.14 - for DOS
                         use Prestige's CI command sequences:
                        1.) sys trcl cl
                        2.) sys trcl sw on
                        3.) sys trcp sw on
                        4.) ... connect to remote node
                                for example: dev dial 1
                        5.) ... disconnect from remote node
                                for example: dev chan drop all
                        6.) sys trcl disp
                        7.) save the dumped tracelog with PKT/PPP/IP data to
                            an ASCII text file.
                        8.) start ZPKT-tool and 'load file', input the name
                            of previous stored ASCII text file.
                        9.) the ZPKT-tool will now interpret all the dumped
                            HEX data and will display the PPP and IP Protocol.
                            You may save this interpreted data into another
                            ASCII text file for further study.



electronic greetings from Vienna, Austria
Manfred Recla
**********************************************************
 ZyXEL European File Distribution - Coordination Center
 eMail:  support@europe.zyxel.com
 FTP:    ftp://ftp.europe.zyxel.com
 WWW:    http://www.europe.zyxel.com
 NEWS:   news://news.europe.zyxel.com
**********************************************************
