\HELP\WIN98\WIN98.TXT

                   ZyXEL FN312 10/100 PCI Adapter
                 ---------------------------------------------
                  Driver Installation for Microsoft Windows 98
                  --------------------------------------------

  Getting Started
  ---------------
  Microsoft Windows Windows 98 do not come bundled with the driver 
  for the adapter.  You must go through the following procedure
  to install the device driver into the Windows 98 system for the 
  adapter to function properly.

  The Windows 98 CD is needed to complete this installation.

  The following installation example illustrates the installation of the 
  Adapter.
  
  Windows 98 Installation Procedure
  ---------------------------------------
  It is recommended that you complete the Windows 98 installation without
  the adapter card in the system.
  
  1.  Shut down the computer and install the adapter into the slot.
      
  2.  Start your Windows 98 system normally.

      Upon power up, it will prompt "PCI Ethernet Controller" in New Hardware
      Found dialog box. The system will indicate to you that a new PCI
      Ethernet Controller has been found.
 
  3.  Select "Search for the best driver for your device(Recommended)", then 
      click "Next" button.

  4.  Insert the "Driver Diskette in your floppy drive".

  5.  Select "Specify a location", and Location of driver:
      "A:\WIN98\FN312.INF" ,then click "Next" button.

  6.  Windows driver file search for the device "ZyXEL FN312 10/100 PCI
      Adapter", and Location of driver: "A:\WIN98\FN312.INF" ,then click 
      "Next" button.
      The Windows 98 CD-ROM is required to be inserted for system files.
      
  7.  Add New Hardware Wizard Table show "ZyXEL FN312 10/100 PCI Adapter",
      then click "Finish" button. Follow screen instructions to complete
      the process.

  8.  Restart your computer.
 

  Advanced Setup
  --------------
  The driver configures the adapter card to operate in autosensing
  mode by default.  In this mode, the card automatically selects the most
  appropriate operating speed and duplex mode.  There might be instances
  when you need to configure the adapter card to operate at a particular
  speed and duplex mode.  The following procedure guides you into the
  Windows 98 system for this setting.

  1.  In Control Panel, open "Network".

  2.  Click on the "ZyXEL FN312 10/100 PCI Adapter" selection.
      Then, clickon the "Properties" button.

  3.  Click on the "Advanced" memu tab in the adapter card window.

  4.  Click on the "Link Speed/Duplex Mode" property selection.

  5.  The "NetworkMedia" windows will show the following possible selections:

         Auto Mode
        10Half Mode                       
        10Full Mode
        100Half Mode                      
        100Full Mode

      Choose the appropriate setting as needed.


  