<<Fujitsu 3.5" SCSI MO Disk Device Driver ver 2.1 (US version)>>

  Thank you very much for purchasing our FUJITSU SCSI MO Device Driver Package.
Here is some inmportant information about using MO disk drive and this software 
package.  Please read this document and MANUAL.TXT.

<<Installation>>

   Follow these steps to install this device driver package.
 
   1. Insert the driver diskette into drive A.

   2. Open an OS/2 full-screen or OS/2 window session.

   3. At the OS/2 command prompt, type the following command.
            > DDINSTALL
       Then press 'Enter'.

   4.  Check the Source and Destination directory, then click on "Install"
          
   5. Select device driver, and click [Ok] to start installation.
  
   6. When the installation is complete, shut down your system, remove the
      diskette, and restart your system. 
  

<<NOTES>>
 
  1.  If you have installed optical disk support of OS/2, the following line 
    is added in the 'config.sys'.
 
      DEVICE=OPTICAL.SYS (in the case of OS/2 Warp 3.0)
      DEVICE=c:\os2\boot\OPTICAL.DMD (in the case of OS/2 Warp 4.0)

    But either device driver is not compatible with this package. 
    Therefore please modify the above line and comment out as follows.
 
      REM DEVICE=OPTICAL.SYS (in the case of OS/2 Warp 3.0)
      REM DEVICE=c:\os2\boot\OPTICAL.DMD (in the case of OS/2 Warp 4.0)
 
  2.  Do not eject MO diskette while MODISK.SYS is starting.  That is, do not
    press eject button until MODISK.SYS is started  when OS/2 is booting and 
    MO diskette is inserted in the MO drive,
 
  3.  FORMAT command of OS/2 does not support 2048 bytes per sector MO disk.
    Therefore please use MOFORMAT instead of FORMAT command.
 
    When you move mouse onto the MO drive icon and press right button, 
    [Format]  menu will appear. But this means standard FORMAT command.  So do 
    not use  this operation for 2048 bytes per sectored MO disk.
 
  4.  If you use Warp 4.0, the following error message may be displayed when you 
    access MO disk for the first time after logical formatting.  But it is not 
    error in fact. 
    Please click [OK] and continue your operation.
 
        5908 " "
          An error has occured and the
          message is not accessible. Contact
          the supplier of the application.

  5.  If you don't like the icon of MO drive, you can change it. Please do the
    following:
    
    1. Move mouse to the the drive icon and press right button. Then pop-up
       menu is appeared.
    2. Select 'Properties'. 
    3. Select 'Icon' page and show [Current icon]
    4. Display your favorit icon on the screen.
    5. Move mouse to your favorit icon and press right button.
    6. Drag the mouse to the drive icon in [current icon] of drive properties.
    7. Release mouse button. And close drive properties. 
     

   Dec. '96    - Fujitsu co. LTD.-


