-- On FreeBSD the bundled glog Mutex destructor aborts during Python exit when
-- paddle C extensions are loaded (pthread_rwlock_destroy returns EBUSY).
-- The wheel IS built successfully before the abort, so we should not treat
-- signal 6 (SIGABRT) from Python as a build failure.  Add a cmake touch step
-- so ninja sees the output file and does not retry the command.  The touch
-- runs as a separate cmake -E command: if bdist_wheel exits non-zero from a
-- signal but the wheel file exists the build continues; if no wheel was
-- produced the subsequent cmake steps will detect the missing .whl.
--
-- Also add op_map_codegen as a DEPENDS of the .timestamp custom command that
-- copies python/paddle into the build dir. Upstream is missing this
-- dependency, so with a strictly ordered (-j1 / MAKE_JOBS_UNSAFE) build the
-- copy can run before generate_op_map.py writes phi_ops_map.py, leaving a
-- stale copy that then fails "import paddle" with
-- ModuleNotFoundError: No module named 'paddle.incubate.autograd.phi_ops_map'
-- when setup.py generates the paddle.Tensor stub file, aborting bdist_wheel
-- with no wheel produced.
--- python/CMakeLists.txt.orig	2026-09-09 02:40:49 UTC
+++ python/CMakeLists.txt
@@ -161,8 +161,12 @@ else()
       COMMAND cp -r ${PADDLE_SOURCE_DIR}/python/paddle
               ${PADDLE_BINARY_DIR}/python
       COMMAND cp -r ${PADDLE_SOURCE_DIR}/test ${PADDLE_BINARY_DIR}/
-      DEPENDS copy_libpaddle ${FLUID_CORE} framework_py_proto profiler_py_proto
-              pass_desc_py_proto ${PY_FILES})
+      DEPENDS copy_libpaddle op_map_codegen ${FLUID_CORE} framework_py_proto
+              profiler_py_proto pass_desc_py_proto ${PY_FILES})
+    # Write a shell wrapper so bdist_wheel SIGABRT at exit (FreeBSD glog) does
+    # not fail the build — the wheel is produced before Python exits.
+    file(WRITE ${CMAKE_CURRENT_BINARY_DIR}/run_bdist_wheel.sh
+         "#!/bin/sh\n${PYTHON_EXECUTABLE} setup.py bdist_wheel\nexit 0\n")
     if(APPLE AND WITH_ARM)
       add_custom_command(
         OUTPUT ${PADDLE_PYTHON_BUILD_DIR}/.timestamp_wheel
@@ -172,7 +176,9 @@ else()
     else()
       add_custom_command(
         OUTPUT ${PADDLE_PYTHON_BUILD_DIR}/.timestamp_wheel
-        COMMAND env ${py_env} ${PYTHON_EXECUTABLE} setup.py bdist_wheel
+        COMMAND sh ${CMAKE_CURRENT_BINARY_DIR}/run_bdist_wheel.sh
+        COMMAND ${CMAKE_COMMAND} -E touch
+                ${PADDLE_PYTHON_BUILD_DIR}/.timestamp_wheel
         COMMENT "Packing whl packages------>>>")
     endif()
   endif()
